Parasound 275 V.2 User Manual Page 1

Model 275 v.2 Two Channel Amplifier OWNER’S GUIDE

10 Turn On Options Switch For convenience, there are three ways the Model 275 v.2 can be turned on and off: • Manually, by pressing the Power butt

11 12 Volt Input Jacks The Model 275 v.2 12V input uses a 3.5mm jack (mono). To use the 12V trigger, insert the trigger wire plug into this jack a

12 Front Panel Operation Power Button Press the Power button once to turn the Model 275 v.2 on. Press it again to turn it off. When the uni

13 Problems and Remedies Unit Will Not Turn On • Check the setting of the Turn On Options switch. (The front panel Power button will be disabled i

14 Are You Having Difficulty? Repair or Service Call your Parasound dealer first. If the dealer can’t help you with your problem we encourage you to

15 Input Impedance - 33 k Ω Input Sensitivity 800 mV for full rated output (28dB) Inter-Channel Crosstalk 80 dB @1 kHz, 72 dB @10 kHz, 65 dB @ 20kH

16 Parasound Products, Inc. 2250 McKinnon Ave, San Francisco, CA 94124 415-397-7100 / Fax 415-397-0144 www.p

2 Important Safety Instructions The lightning flash with the arrowhead symbol within an equilateral triangle is intended to alert the user to the pre

3 Table of Contents Introduction ...4 Placement and Ventilation Guidelines ...

4 INTRODUCTION Thank You for Choosing Parasound Your new Parasound Model 275 v.2 power amplifier has been designed with proven class AB amplifier

5 Unpacking Your Model 275 v.2 & Placement Guidelines Unpacking Your Model 275 v.2 Carefully remove your Model 275 v.2 from its shipping carton

6 AC Mains Voltage NOTE: Before you plug this amplifier into an AC mains outlet: 115v - 230v AC Voltage Selector Switch This switch is found on t

7 R (Right) and L (Left) Level Knobs To increase the listening level for each channel turn its Level knob clockwise. To decrease the listening level

8 Speaker Connections Speaker Terminals There are separate speaker terminals for two pairs of speakers, labeled Speaker Pair A and Speaker Pair B.

9 How to set the Speaker Load switch when the Model 275 v.2 is configured for Bridged Mono operation: Single 8 Ohm Speaker In this case the Speaker