Parasound AVC-2500 User Manual download pdf (Page 25)

AVC 2500 Remote Control Buttons

On-Off

This button operates the same as the On-Off button on the front panel. There are also separate

on and off control codes for ease of use while setting up macros or programming external

system controllers. Press the On-Off to turn the unit on or off. Press Shift + THX for an

on-only command. Press Shift + On-Off for an off-only command.

Digital

The Digital

g g

g and

h h

h buttons allow you to cycle up or down in either direction to select any

of the eight digital inputs, the 5.1 channel analog input, or analog.

Surround

The Surround

g g

g and

h h

h buttons allow you to cycle in either direction to select the five

Autoformating Surround Processing modes including Cinema, Stereo, Music, Party, and

Mono.

THX

Press the THX button to engage THX Ultra processing for any of the Cinema Surround

modes, including Dolby Digital, Dolby Pro Logic, DTS, and mono.

Dynamic Range Control

The Dyn button engages a fixed degree of Dynamic Range Control that is available if the

DVD you’re playing includes it in its digital bitstream. This feature adds dynamic range

compression to allow soundtracks with a high dynamic range to maintain clear audibility

even at low levels. Dynamic Range Control is often called the nighttime listening mode.

Setup/Trim

Press and hold this button to initiate the setup operation of the AVC-2500. Press and release

this button to temporarily trim individual channel levels to suit your taste while watching a

film or listening to a recording.

Mute

Press the Mute button to interrupt the audio signal from reaching the Main analog output

jacks of the AVC-2500. The Mute button does not affect the Record Output jacks or the Zone

Output jacks (unless Zone is presently under control).

Volume

The Volume

g g

g and

h h

h buttons adjust the master volume up and down in 1 dB steps. These

same

buttons are also used for making adjustments during Setup and Trim operations.

Tune

f f

/ Auto Audio

When the tuner is activated, pressing this button normally selects the previous station preset.

If you pressed the Tuning button once before pressing the Tune

f f

f button, then each time

you press the Tune

f f

f button it will select the previous broadcast frequency. If you pressed

the Tuning button twice before pressing the Tune

f f

f button, each time you press the Tune

button it will tune down 50 kHz.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 62 63

Comments to this Manuals

No comments

Parasound AVC-2500 User Manual Page 25

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Parasound AVC-2500